TY - JOUR
T1 - Assessment of Skempton's pore water pressure parameters B and A using a high-capacity tensiometer
AU - Sanlon, Philip
AU - Sivakumar, Vinayagamoothy
AU - Solan, Brian
AU - Tripathy, Snehasis
AU - MacKinnon, Pauline
AU - Donohue, Shane
AU - Ramaiah, Bathala Janaki
PY - 2019/10/14
Y1 - 2019/10/14
N2 - Saturation of soils is a prerequisite in many laboratory tests involving consolidation, permeability and stress-strain behaviour. The saturation process is usually time consuming, particularly in clay-rich soils, and this can incur substantial cost and potential delays in reporting findings. The saturation of samples is assessed using the well-established Skempton’s pore water pressure parameter B. In a situation where the soil is fully saturated the B-value is approximately one. It is often the case that fine soil samples extracted from the ground, particularly those from below the water table, remain saturated. However, current testing protocols require evidence to verify a complete saturation prior to subsequent laboratory investigations. This paper reports experimental results exploring the hypothesis that, if the sample is ‘perceived’ to be saturated, then further saturation procedures may not be necessary to obtain reliable geotechnical parameters. Laboratory investigations were conducted on three different clays (Kaolin Clay, Belfast Clay and Oxford Clay) in a testing chamber instrumented with a high capacity tensiometer. The confining pressures were applied in a ramped fashion under undrained conditions. The response of the tensiometer confirmed that the samples were saturated from the very beginning of the loading process, as implied by the B-value being close to one. Further supplementary investigations were carried out to assess the Skempton’s pore water pressure parameter A and the stress-strain behaviour of the soils. The combined finding provides further evidence to suggest that the saturation process as suggested in standards may not be necessary for fine grained soils to establish reliable geotechnical design parameters.
AB - Saturation of soils is a prerequisite in many laboratory tests involving consolidation, permeability and stress-strain behaviour. The saturation process is usually time consuming, particularly in clay-rich soils, and this can incur substantial cost and potential delays in reporting findings. The saturation of samples is assessed using the well-established Skempton’s pore water pressure parameter B. In a situation where the soil is fully saturated the B-value is approximately one. It is often the case that fine soil samples extracted from the ground, particularly those from below the water table, remain saturated. However, current testing protocols require evidence to verify a complete saturation prior to subsequent laboratory investigations. This paper reports experimental results exploring the hypothesis that, if the sample is ‘perceived’ to be saturated, then further saturation procedures may not be necessary to obtain reliable geotechnical parameters. Laboratory investigations were conducted on three different clays (Kaolin Clay, Belfast Clay and Oxford Clay) in a testing chamber instrumented with a high capacity tensiometer. The confining pressures were applied in a ramped fashion under undrained conditions. The response of the tensiometer confirmed that the samples were saturated from the very beginning of the loading process, as implied by the B-value being close to one. Further supplementary investigations were carried out to assess the Skempton’s pore water pressure parameter A and the stress-strain behaviour of the soils. The combined finding provides further evidence to suggest that the saturation process as suggested in standards may not be necessary for fine grained soils to establish reliable geotechnical design parameters.
U2 - 10.1680/jgeot.18.P.191
DO - 10.1680/jgeot.18.P.191
M3 - Article
SN - 0016-8505
VL - 71
SP - 1
EP - 10
JO - Geotechnique
JF - Geotechnique
IS - 2
ER -