Brittle-ductile transition during diamond turning of single crystal silicon carbide

Saurav Goel, Xichun Luo, Paul Comley, Robert L Reuben, Andrew Cox

Research output: Contribution to journalArticlepeer-review

116 Citations (Scopus)

Abstract

In this experimental study, diamond turning of single crystal 6H-SiC was performed at a cutting speed of 1 m/s on an ultra-precision diamond turning machine (Moore Nanotech 350 UPL) to elucidate the microscopic origin of ductile-regime machining. Distilled water (pH value 7) was used as a preferred coolant during the course of machining in order to improve the tribological performance. A high magnification scanning electron microscope (SEM FIB- FEI Quanta 3D FEG) was used to examine the cutting tool before and after the machining. A surface finish of Ra=9.2 nm, better than any previously reported value on SiC was obtained. Also, tremendously high cutting resistance was offered by SiC resulting in the observation of significant wear marks on the cutting tool just after 1 km of cutting length. It was found out through a DXR Raman microscope that similar to other classical brittle materials (silicon, germanium, etc.) an occurrence of brittle-ductile transition is responsible for the ductile-regime machining of 6H-SiC. It has also been demonstrated that the structural phase transformations associated with the diamond turning of brittle materials which are normally considered as a prerequisite to ductile-regime machining, may not be observed during ductile-regime machining of polycrystalline materials.
Original languageEnglish
Pages (from-to)15-21
Number of pages7
JournalInternational Journal of Machine Tools and Manufacture
Volume65
Issue numberFebruary
DOIs
Publication statusPublished - Feb 2013

ASJC Scopus subject areas

  • Industrial and Manufacturing Engineering
  • Mechanical Engineering

Fingerprint Dive into the research topics of 'Brittle-ductile transition during diamond turning of single crystal silicon carbide'. Together they form a unique fingerprint.

Cite this